【摘 要】
：
The effects of low temperature thermo-mechanical treatment (LTTMT) on microstructures and mechanical properties of Ti-6Al-4V (TC4) alloy were studied by optical
【机 构】
：
School of Materials Science and Engineering,Key Laboratory of Nonferrous Metal Materials Science and
论文部分内容阅读
The effects of low temperature thermo-mechanical treatment (LTTMT) on microstructures and mechanical properties of Ti-6Al-4V (TC4) alloy were studied by optical microscopy (OM), tensile test, scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The experimental results confirm that the strength of TC4 alloy can be improved obviously by LTTMT processing, which combines strain strengthening with aging strengthening. The effect of LTTMT on the alloy depends on the microstructure of the refined and dispersed α+β phase on the basis of high dislocation density by pre-deformation below recrystallization temperature. The tensile strength decreases with the increase of pre-deformation reduction. The optimal processing parameters of LTTMT for TC4 alloy are as follows:solution treatment at 900 ℃ for 15 min, pre-deformation in the range of 600-700 ℃ with a reduction of 35%, finally aging at 540 ℃ for 4 h followed by air-cooling.
其他文献
文章分析了建筑物外墙渗水的原因,从设计和施工两方面提出了预防建筑物外墙渗漏的措施,提出了三种处理建筑物外墙渗漏的方法,从而减少建筑物外墙渗漏的发生。
The paper ana
奥尔森教授认为。在非市场的集体行动中。只要集体物品给个人带来的利益大于集体物品的总成本。个人就愿意为集团提供集体物品。本文对这一观点进行了补充，进一步认为，只要集体
In order to eliminate noise interference of metal magnetic memory signal in early diagnosis of stress concentration zones and metal defects, the empirical mode
Microwave irradiation was employed to assist the synthesis of poly(amino-quinone) (PAQ) from p-benzoquinone and diamines in solid state. The effects of power, t
在分析性能退化数据模型的基础上,针对Wiener过程性能退化产品提出了一种可靠性评估的Bayes方法,给出了参数的递推估计.该方法计算简单,并且能随着性能退化试验进行不断更新
Nano-scale γ-AlOOH with various morphologies, such as whisker, bar, ball, and sheet, was synthesized successfully and control-lably through a facile hydrotherm
To find the distribution patterns of dynamic amplification coefficients for dams subjected to earthquake, 3D seismic responses of concrete-faced rockfill dams w
Microstructural evolution and phase transformation induced by different heat treatments of the hypereutectic aluminium-silicon alloy, Al-25Si-5Fe-3Cu (wt%, si
Molecular dynamics simulation was used to simulate the thermodynamic properties of three binary alloys, Pb-Ag (1:1), Pb-Ag (4:1), and Pb-Ag (9:1). The energy fu
Heuristic optimization methods provide a robust and efficient approach to solving complex optimization problems.This paper presents a hybrid optimization techni