【摘 要】
：
Composite nanofiber membranes based on biodegradable poly(lactic acid) (PLA) and cellulose nanofibrils (CNF) were produced via electrospinning.The influence of CNF content on the morphology,thermal properties,and mechanical properties of PLA/CNF composite
【机 构】
：
School of Materials Science and Engineering, Fuzhou University, Fuzhou 350116, China;School of Mater
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
论文部分内容阅读
Composite nanofiber membranes based on biodegradable poly(lactic acid) (PLA) and cellulose nanofibrils (CNF) were produced via electrospinning.The influence of CNF content on the morphology,thermal properties,and mechanical properties of PLA/CNF composite nanofiber membranes were characterized by field scanning electron microscopy (FE-SEM),differential scanning calorimetry (DSC),thermogravimetric analysis (TGA),and dynamic mechanical analysis (DMA),respectively.The results show that the PLA/CNF composite nanofibers with smooth,flee-bead surface can be successfully fabricated with various CNF contents.The introduction of CNF is an effective approach to improve the crystalline ability,thermal stability and mechanical properties for PLA/CNF composite fibers.The Young\'s moduli and tensile strength of the PLA/CNF composite nanofiber reach 106.6 MPa and 2.7 MPa when the CNF content is 3％,respectively,which are one times higher and 1.5 times than those of pure PLA nanofiber.Additionally,the water contact angle of PLA/CNF composite nanofiber membranes decreases with the increase of the CNF loading,resulting in the enhancement of their hydrophilicity.
其他文献
Nitrogen doped multi-channel graphite was successfully prepared by using nitrogen doping and KOH etching technologies. The three-electrode and EIS tests indicates that the etched graphite possesses lower electrochemical resistance than the pristine graphi
The viability of using polypropylene fibers (PPF) in concrete was largely studied. Yet, few of the existing research studies investigated the effects of PPF on the properties of concrete containing recycled concrete aggregate (RCA). Mixes with different R
The Be films were prepared by thermal evaporation at different sources to substrate distances (SSD) on glass substrates. The decrease of SSD from 90 mm to 50 mm caused the increase of substrate temperature and the rising density of incident Be atoms, thus
The results of the study of raw mix preparation and foam glass-ceramics production using diatomite as a raw material were presented in the following article. A mixture of diatomite and 40％ NaOH solution was subjected to heating at a constant temperature o
Autoclaved aerated concrete waste (AACW) was used as a raw material to prepare nucleation seed for acceleration of Portland cement. Nano AACW seed with median particle size of 324 nm was prepared by wet grinding method. Both the electrical conductivity an
Ultrafine grain tungsten heavy alloys (WHAs) were successfully produced from the nano-crystalline powders using spark plasma sintering. The present study mainly discussed the effects of sintering temperature on the density, microstructure and mechanical p
Aiming to investigate the mix design of eco-friendly UHPC with supplementary cementitious materials and coarser aggregates, we comprehensively studied the workability, microstructure, porosity, compressive strength, flexural strength, and Young\'s modul
The products of monoammonium phosphate containing Cr3+ resulted in disqualification, and further posed a serious threat to ecological environment and human beings. Herein, the porous adsorbent of fluor(calcium silicate) composites (FCSc) was prepared by h
Ba0.6Sr0.4TiO3 ceramic was synthesized by the sol-gel method combined with the solid-state reaction. Phase composition and microstructure analyses indicate that pure BST phase with aggregated nanograins can be achieved. The dielectric properties change wi
Nano-diamond like carbon (DLC) thin films were prepared on fused silica and Cu substrates by the pulsed-laser deposition technique with different laser intensities. Step-measurement, atomic force microscope (AFM), UV-VIS-NIR transmittance spectroscopy and