机械维修中,有时会遇到散了架的径向轴承。它的外圈在盲孔内,或内圈紧靠在轴的台阶上,要取出内圈或外圈很不方便。采用下面介绍的方法,可以顺利地取出内外圈。对于盲孔内的轴承外圈,可先做一个中间制有螺纹的台阶轴,把内圈套在轴上。然后一起放入盲孔内,并使内圈和外圈相切,再放入不少于三颗钢珠,均匀分开。最后用一定长度的螺钉顶出或用拔销器拔出 Mechanical maintenance, sometimes encountered scattered rack radial bearings. Its outer ring in the blind hole, or the inner ring close to the shaft step, to remove the inner or outer ring is very convenient. Using the method described below, you can smoothly remove the inner and outer rings. For the blind hole of the bearing outer ring, you can first make a middle of the threaded shaft step, the inner sleeve on the shaft. Then put it into the blind hole together and make the inner ring and the outer ring tangent, then put in not less than three steel balls evenly. Finally, with a certain length of the top of the screw or unplug unplugged