论文部分内容阅读
在实际生产中经常会遇到在普通镗床上用立铣刀或键槽铣刀进行铣削加工,但由于铣刀没有象铣床一样被拉杆拉1.镗床主轴2.定位螺杆3.锁紧螺母4.定位套5.铣刀6.定位块图11.立铣刀2.刀杆3.螺栓4.垫圈5.销6.圆螺母7.镗床主轴图21.车刀2.卡具图3紧固定,因此在铣削走刀时,铣刀有被拉出
In the actual production often encountered in the ordinary boring machine with an end mill or keyway milling cutter for milling, but because the milling cutter is not the same as the milling rod pulled rod 1. Boring machine spindle 2. Positioning screw 3. Locking nut 4. Positioning sleeve 5. Milling cutter 6. Positioning block Figure 11. End mill 2. Arbor 3. Bolt 4. Washer 5. Pin 6. Round nut 7. Boring spindle Figure 21. Turning tool 2. Fixture Figure 3 Fastening , So when milling the cutter, the cutter is pulled out