论文部分内容阅读
附图所示的装置是进口陶瓷设备液压成形机上的一种新颖的三角皮带无级变速器。其结构原理如下: 压簧6使动轮11、15与定轮14组成一体,皮带轮轴16上的扁销7和定轮14、动轮11、15相联接,定轮的另一边装有一短圆销8,动轮12、15可上下移动,从而保证了变速器能正常地工作。为了使动轮滑动自如,皮带轮轴内腔装有润滑油。该变速器可安装在相应的机构上,只要把皮带轮轴16的孔和相应机构的轴用键联接,旋紧螺钉17后即可使用。变速器用两根三角皮带与电机皮带轮相联接,电
The device shown in the figure is a novel V-belt CVT on the hydroforming machine of the imported ceramic equipment. The principle of the structure is as follows: the compression spring 6 integrates the driving wheels 11 and 15 with the fixed wheel 14, the flat pin 7 on the pulley shaft 16 is connected with the fixed wheel 14 and the moving wheels 11 and 15, and the other side of the fixed wheel is equipped with a short pin 8, moving wheels 12,15 can move up and down, thus ensuring the transmission can work properly. In order to slide the wheel freely, the pulley shaft cavity is filled with lubricating oil. The transmission can be mounted on a corresponding mechanism as long as the hole of the pulley shaft 16 and the shaft of the corresponding mechanism are keyed together and the screw 17 can be tightened to be used. Transmission with two V-belt and motor pulley connected, electricity