论文部分内容阅读
一、离心除尘器在1973年11月一机部上海除尘和废气处理经验交流会上,同济大学介绍了正在研制中的离心除尘器的试验情况,湖南大学及一机部洛阳设计院等单位也书面介绍新设计的除尘器的试验情况。无产阶级文化大革命以来,各地同志对新型除尘器的研究情况很关心,为此将有关情况简介如下,供参考。1.T-11型旋风除尘器这是同济大学暖通教研室为适应消烟除尘工作的需要,在分析现有各种旋风或离心除尘器的优缺点的基础上,吸取了它们的优点,自行设计的一种旋风除尘器,其示意图见图1。采用蜗壳型进风口、条缝形进口对提高分离灰尘能力有好处;旁室对克服顶部
I. Centrifugal Dust Collector In November 1973, an experience exchange meeting of the Shanghai Department of Dust Collection and Waste Gas Treatment was held in Tongji University. The Tongji University introduced the experimental conditions of the centrifugal dust collector under development. The Hunan University and the Department of Primary Engineering Luoyang Design Institute and other units also Written introduction of newly designed dust collectors. Since the proletarian cultural revolution, all local comrades have been very concerned about the research situation of the new type of dust collector. To this end, the relevant circumstances are described below for reference. 1.T-11 type cyclone dust collector This is the need of the Tongji University HVAC department to adapt to the smoke and dust removal work. Based on the analysis of the advantages and disadvantages of various existing cyclones or centrifugal dust collectors, they draw on their advantages and make their own The design of a cyclone dust collector, its schematic diagram shown in Figure 1. The use of volute inlets and slat-shaped inlets is good for improving the ability to separate dust; the side chambers overcome the top