在机床维修中,常常因重新安装零件或经过一定时间的运转而造成主轴径向跳动,轴向窜动,丝杠与导轨不平行,拖板或滑枕压板、斜铁与导轨的松动,离合器的松动,丝杠与丝母之间的间隙过大等故障,需要作重新调整。如果调整得当,机床在运转中就有可靠的稳定性,发热量和噪声小,动作灵活,既可以延长机床使用寿命,也能保证加工质量。根据自已多年的实践经验,对机床修理中的一些典型调整方法作一介绍。 In the machine maintenance, often due to re-install the parts or after a certain period of time the operation caused by the spindle radial runout, axial movement, screw and rail is not parallel, carriage or pillow block plate, ramp and rail loose, clutch The loose, the gap between the screw and the nut is too large and so on, need to be readjusted. If properly adjusted, the machine has reliable operation in operation, heat and noise, flexible operation, both to extend the service life of the machine, but also to ensure the quality of processing. According to their own many years of practical experience, some typical methods of machine tool repair to make an introduction.