austenite相关论文
普遍存在于现代钢铁生产连铸坯中的柱状晶，其组织形貌和晶体学的各向异性显著影响后续工艺下的组织、 织构及性能。利用x射线衍射和......
铬在铸铁中有三个主要用途:生成碳化物,使之具有耐腐蚀性,使组织保持稳定以便于高温使用。通常加入少量的铬,以稳定灰铸铁中的珠光......
Research status of high strength low alloy TRIP (transformation induced plasticity) steels for automobile structural pa......
On the basis of transformation kinetics and thermodynamics, the austenite-ferrite transformation start temperature duri......
A new kind of high strength, high toughness and high plasticity spring steel has been developed. The strength, the redu......
Dual phase heat treatment is an economical and effective way for improving the properties of low carbon steels and low-a......
Hot deformation experiments were carried out on Gleeble 1500 thermo-mechanical simulator. The bainite transformation aft......
The delayed fracture behavior of medium-carbon high strength spring steel containing different amounts of boron (0.000 5......
An integrated mathematical model is developed to predict the microstructure evolution of C-Mn steel during multipass hot......
Martensitic microstructure in quenched and tempered 17CrNiMo6 steel with the prior austenite grain size ranging from 6μ......
The influences of thermal stabilization of austenitic on the onset temperature for a martensite transformation in T91 fe......
Gray cast iron that is used for automobile engine cylinder liners was laser surface hardened using Nd∶YAG quasi-continu......
We explore the application of electropulsing for the control of phase transformation in a low-carbon steel. The effect o......
Small dispersoid particles inhibit recrystallization which is critical in controlling the grain structure of many high s......
In this research,aging treatments at temperatures of 800 and 900°C for different aging time of 5-60 min were conducted ......
Note:This book consists of five sections:Chapter 1 Introduction,Chapter 2 Grey Iron,Chapter 3 Ductile Iron,Chapter 4 Ver......
On-line thermo mechanical controlled processing(TMCP) was conducted to develop the third generation high strength low al......
A new design of copper-bearing non-quenched plastic mold steel is presented and explained. Two kinds of microstructure c......
Modeling Recrystallization of Austenite for C-Mn Steels during Hot Deformation by Cellular Automaton
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
Using thermomechanical simulation experiment, the kinetics of the isothermal transformation of austenite to ferrite in t......
Effect of Austenite Deformation on Continuous Cooling Transformation Microstructures for 22CrSH Gear
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
Duplex stainless steels are gaining global importance because of the need for a high strength corrosion resistant materi......
Modeling of microstructural evolution during dynamic recrystallization in coarse Nb microalloyed aus
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
Constituent phases of the passive film formed on 2205 stainless steel by dynamic electrochemical imp
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
Kinetics of bainite-to-austenite transformation during continuous reheating in low carbon microalloy
A dilatometer was used to study the kinetics of bainite-to-austenite transformation in low carbon microalloyed steel wit......
Characterization of the structural details of residual austenite in the weld metal of a 9Cr1MoNbV we
The existence of residual austenite in weld metal plays an important role in determining the properties and dimensional ......
Effect of initial microstructure on austenite formation kinetics in high-strength experimental micro
Austenite formation kinetics in two high-strength experimental microalloyed steels with different initial microstructure......
Variation in retained austenite content and mechanical properties of 0.2C-7Mn steel after intercriti
The effects of annealing time and temperature on the retained austenite content and mechanical properties of 0.2C-7Mn st......
Analysis of phase transformation from austenite to martensite in NiTi alloy strips under uniaxial te
为探究吕家坨井田地质构造格局,根据钻孔勘探资料,采用分形理论和趋势面分析方法,研究了井田7......
Effect of Austenite Deformation on Continuous Cooling Transformation Microstructures for 22CrSH Gear
The effect of compressive deformation of austenite on continuous cooling transformation microstructures for 22CrSH gear ......
The effect of sub-zero cooling on microstructure and mechanical properties of a low alloyed austempered ductile iron has......
The austenitizing temperature controls the carbon content of the austenite which, in turn, influences the structure and ......
The thermal stability of an ADI has been studied by isothermal aging at 350℃ for 150 hours, measuring the amount of ret......
The cavitation erosion (CE) behavior of CrMnN ferrite-austenite duplex stainless steel in distilled water and 3% NaCl so......
Modeling of microstructural evolution during dynamic recrystallization in coarse Nb microalloyed aus
The aim of the current study was to investigate the microstructural evolution during dynamic recrystallization in coarse......
Analysis of phase transformation from austenite to martensite in NiTi alloy strips under uniaxial te
Phase transformation from austenite to martensite in NiTi alloy strips under the uniaxial tension has been observed in e......
By careful design of rolling schedule, ultra-fine (～2 μm) ferrite grains in a low carbon high niobium (0.09wt%Nb) micro-......
The Q345 plate steel austenite recrystallization behavior and strain accumulation during rolling were investigated throu......
Metallographic etching and microstructure characterization of NiCrMoV rotor steels for nuclear power
The grain size of prior austenite has a distinct influence on the microstructure and final mechanical properties of stee......
Characterization of the structural details of residual austenite in the weld metal of a 9Cr1MoNbV we
The existence of residual austenite in weld metal plays an important role in determining the properties and dimensional ......
In situ observation of austenite grain growth behavior in the simulated coarse-grained heat-affected
The austenite grain growth behavior in a simulated coarse-grained heat-affected zone during thermal cycling was investig......
The austenite formation kinetics in unalloyed cast ductile iron was studied on the basis of dilatometry measurements, an......
某电厂300MW机组锅炉在投产运行仅仅13260小时便发生了屏式过热器爆管事故,经初步分析该不锈钢管弯管是由于固溶化处理不当,在残余......
在研究团球γ+(Fe,Mn)3C共晶体增强奥氏体钢基自生复合材料(EAMC)的力学与耐磨性能的基础上,分析了EAMC的强韧化及耐磨机理.结果表......
研究了X70管线钢模拟热影响区的局部脆化现象和临界再热粗晶区粒状贝氏体的形成及其对韧性的影响规律.结果表明,二次峰值温度为780......
