【摘 要】
：
In recent years, energy saving and environmental protection have caused widespread concern.Using the aluminum alloys for the vehicle can reduce the weight of the vehicle to reduce energy consumption.6
【机 构】
：
University of Science and Technology Beijing, China
【出 处】
：
15th International Conference on Aluminium Alloys(ICAA15)(第十
论文部分内容阅读
In recent years, energy saving and environmental protection have caused widespread concern.Using the aluminum alloys for the vehicle can reduce the weight of the vehicle to reduce energy consumption.6XXX aluminum alloys have been used in automobile industry because of its excellent comprehensive properties.
其他文献
This paper studied morphology and structure of iron-rich phase in the aluminium alloy using electrolytic separation technology, which content of iron was 0.3%, 0.6%, 1%, 0.6%, 2% and 5%.Results showed
Cu and Ag addition to Al alloys can enhance its mechanical properties due to solid solution hardening and precipitation hardening by aging treatment.Alloying elements affect a precipitation sequence a
Wire-Arc Additive Manufacturing (WAAM) is highly efficient, can achieve high deposition rates and does not rely on expensive equipment.WAAM thus has the potential to produce large scale, near net-shap
In this study we focused on the influence of nano-size B4C particles (～60 nm) on microstructure and mechanical behavior of Al-2024/B4C composites.The experiment involved ball milling of 2024-Al and B4
Al-Zn-Mg alloys are widely used in aircraft and automotive industries for structure components because of exceptionally high specific strength in the fully aged condition.Precipitation sequence for Al
Dispersoids play a significant role in the recrystallization and texture development for wrought Al-Mg-Si (6xxx series) alloys by inhibiting grain boundary motion.It is therefore important to understa
Al-7 wt％ Si ahoy was treated by the high pressure solution (2 GPa) and natural aging, and precipitation behavior of the dispersoids in the alloy was investigated through TEM to provide a possible form
In this study the influence of natural aging in energy absorbance capacity of 6xxx series extruded profiles after artificial aging is examined by means of optical and scanning electron microscopy, qua
The solution process of a Al-Mg-Si alloy is heated by electric resistance wire and hot air respectively.Specimens were performed at 560℃ for 30 min and then cooled by water quenching.Immediately, the
In this paper, 40 mm thick A7N01-T5 aluminum alloy plate was friction stir welded using a double side process.The microstructure evolution of different zones of the joint, which is significantly affec