【摘 要】
：
Cathode is the most important composition for lithium ion battery.The olivine structure lithium iron phosphate (LiFePO4) with its numerous appealing features such as high theoretical capacity, accepta
【出 处】
：
2012 Postdoctoral Symposium of China on Materials Science &
论文部分内容阅读
Cathode is the most important composition for lithium ion battery.The olivine structure lithium iron phosphate (LiFePO4) with its numerous appealing features such as high theoretical capacity, acceptable operating voltage, high safety, environmental benignity and low cost, has attracted extensive interest as a potential cathode material.As a precursor, FePO4 can be produced to LiFePO4 in a large scale with high tape density, discharge rate and capacity.This can be realized by controlling the crystal size and morphology of FePO4.The characteristics, structure and produce methods of FePO4 are discussed in the review.It shows the relative merits of these produce methods, gives some suggestions to improve it.
其他文献
Effects of cooling conditions on the microstructure of semisolid AZ91 slurry produced via ultrasonic vibration process were investigated.AZ91 melts were subjected to ultrasonic vibration in different
Dynamic mold temperature injection technology can be used to eliminate many surface defects such as weldline, flow mark that usually appear on the polymer parts.In this paper, fiber reinforced ABS mat
Dielectric properties and varistor performance of sol-gel prepared Ni-doped calcium copper titanate ceramics (CCNTO) were investigated.The XRD patterns showed that the CaCu3NixTi4O12+x (CCNTO) (x =0,
(Ba0.7, Sr0.3)Nb2O6-(1-y)(Ba0.7, Sr0.3)TiO3 (SBN/BST in short) composite ceramics with different Nb/Ti ratios were fabricated using a Powder-Sol (P-S) method with Nb2O5 fine powders suspended in the b
The (Mol-xNbx)Si2 (0≤x≤0.5) was successfully prepared using the combustion synthesis method by Mo, Nb, and Si elemental powders.The influences of niobium on the combustion mode, combustion temperature
To further enhance shape memory effect (SME) and improve treatment technique in Fe-based shape memory alloys, an Fel7Mn5Si8Cr5Ni0.5NbC alloy was subjected to electropulsing treatment after pre-deforma
Al2O3-13wt%TiO2 coatings, formed by means of laser cladding on nickel-based alloy, were heated using high frequency induction sources.The coating and the interface between bond coating and ceramic coa
Using electrodeposition combined with slurry pack cementation, with TiO2 as titanizing source, pure Al powder as reducer, electroplated specimens with a layer of electroplating nickel originally depos
Electro-Slag Remelting(ESR) technology often used in the preparation of aerospace materials such as high temperature alloys, the shape of the molten pool is a key factor to get the high quality ESR in
More recently, zirconium nitride (ZrN) films are getting considerable attentions not just because of its warmer golden color, but its significant performance advantages over TiN films during drilling