【摘 要】
：
Purification of wastewater containing dyes just by photocatalytic degradation under visible light irradiation is usually a slow process, especially for the cases of high concentration dyes in water.Fr
【机 构】
：
School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Be
【出 处】
：
2010中国可再生能源科技发展大会
论文部分内容阅读
Purification of wastewater containing dyes just by photocatalytic degradation under visible light irradiation is usually a slow process, especially for the cases of high concentration dyes in water.From the viewpoint of economy and efficiency, decreasing the dyes concentration of wastewater to an optimal level suitable for visible light photocatalytic degradation is one of the methods to adopt.Based on the above idea, a novel treatment process was designed for dye removal from water, which consisted of biosorption and photocatalysis under the visible light irradiation.High concentration (~100mg/l) of dye waste water will be decreased rapidly after fast biosorption onto the biosorbents such as saponified apple juicing residue, sweet-stick bagasse, and then the obtained waste water with low concentration (~5mg/l) of dye will much easier be degraded thoroughly under visible light irradiation in short time.The basic experiments were conducted to evaluate the principal characteristics of these two unit operations, and their removal behaviour of dye molecules from water was clarified respectively.The process exhibits the outstanding advantages, i.e., much faster, more thorough, and energy saving, showing the great perspective for the dye waste water cleaning in industry.
其他文献
Computational fluid dynamics (CFD) simulations are conducted using the volume-of-fluid (VOF) method to investigate the heat transfer property of falling liquid film evaporator in vertical wavy tube.Th
The amorphous silicon (a-Si) thin films were deposited by PECVD and then were annealed by RTP.Using the Fourier infrared conversion spectrum scanning, electronic microscope and X-ray-diffraction techn
The effect of different buffers on the polycrystalline silicon(poly-Si) texturization was investigated The surface morphology and reflectance of poly-Si were analyzed by scanning electron microscope (
Over 400 organic compounds exist in bio-oil, and the analysis of bio-oil physicochemical properties is tedious, time-consuming, and expensive.This study investigated the feasibility of using Fourier T
Power generation capacity adjustment-type exhaust gas turbocharged power generation system uses the thermal energy and kinetic energy in the internal combustion exhaust gas to propel compressor and ge
The calculation method of numerical simulation and FLUENT software were combined, to have three dimensions numerical simulation of the heat pipe air pre-heater, the fluid flow and thermal performance
Based on a well-designed collector/evaporator, a novel direct expansion solar assisted heat pump water heater is introduced.The device can work by four modes according to solar and ambient temperature
Firstly, the paper analyses the feasibility of solar energy utilization at the western region of Gansu, in view of characteristics of this region.There are fewer rainy days throughout the year, higher
By using double-grate biomass briquette combustion equipment, influential factors of slagging characteristic are experimented which are about furnace-tank temperature, thickness of fuel, diameter of f
Fossil resources are increasingly exhausted with the rapid development of mankind activities, and in the community all kinds of attempts are being carried out urgently searching for the alternatives t