Instantaneous measurement for radar target polarization scattering matrix

来源 :系统工程与电子技术(英文版) | 被引量 : 0次 | 上传用户:lisky
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Adopting "simultaneous transmitting, simultaneous receiving" operational scheme, instantaneous polarization radar (IPR) can measure target polarization scattering matrix (PSM)using only once target echoes in two orthogonal polarization channels. Firstly, signal model and signal process are advanced under narrowband condition. Secondly, measurement performances of two typical IPR waveforms are analyzed in detail. At last, field experiments are carried out using X-band IPR system designed by National University of Defense Technology (NUDT), China. Compared with results obtained by alternative polarization measurement scheme, following results can be obtained: the difference of relative amplitude measurement results is smaller than 2dB and that of relative phase measurement results is smaller than 10°,verifying the validity of instantaneous polarization measurement scheme.
其他文献
Fe_2O_3,TiO_2,CuO and ZnO powders were mixed according to the formula of(1-x)TiO_2 xCuO-Fe_2O_3 or (1-x)TiO_2 xZnO-Fe_2O_3(x=0,0.2 0.4,0.6,0.8,1),and well ball-
To make heat conduction equation embody the essence of physical phenomenon under study, dimensionless factors were introduced and the transient heat conduction
In the forward channel of a networked control system (NCS), by defining the network states as a hidden Markov chain and quantizing the network-induced delays to
A two-dimensional computational model coupling an annular electromagnetic stirring(A-EMS)with a macroscopic heat and fluid flow analysis in Al-alloys semisolid
The electrochemical process of galena in a pH 12.8 buffer solution was investigated using chronoamperometry and chronopoten-tiometry. To establish kinetic param
The stiffness matrix of semi-rigidly connected composite beams considering interface slip was established and the calculation method for elastic seismic respons
传统的PID整定方法得到的结果通常不是最优参数,很多学者采用遗传算法和模拟退火方法来解决这个问题.针对遗传算法很容易陷入局部最优值和模拟退火算法收敛速度慢这些缺点,融
研究了在一有限状态马尔可夫环境中运行的具有L个零件和N(N<L)个修理工的并联可修系统.其中故障到达服从一马尔可夫到达过程,修理时间服从位相型分布.写出了描述系统运行模式
In order to improve the cycling stability of AB5 type alloy electrodes, rapid quenching technology and new alloy composition design were employed. A hydrogen st
The thermomechanical coupling simulation of the isothermal equal channel angular pressing(ECAP)of Ti-6Al-4V alloy was conducted.The effect of processing paramet