论文部分内容阅读
The dynamic recrystallization (DRX) simulation performance largely depends on simulated grain topological structures.However,currently solutions used different models for describing two-dimensional (2D) and three-dimensional (3D) grain size distributions.Therefore,it is necessary to develop a more universal simulation technique.A cellular automaton (CA) model combined with an optimized topology deformation technology is proposed to simulate the microstructural evolution of 42CrMo cast steel during DRX.In order to obtain values of material constants adopted in the CA model,hot deformation characteristics of 42CrMo cast steel are investigated by hot compression metalIographic testing.The proposed CA model deviates in two important aspects from the regular CA model.First,an optimized grain topology deformation technology is utilized for studying the hot compression effect on the topology of grain deformation.Second,the overlapping grain topological structures are optimized by using an independent component analysis method,and the influence of various thermomechanical parameters on the nucleation process,grain growth kinetics,and mean grain sizes observed during DRX are explored.Experimental study shows that the average relative root mean square error (RRMSE) of the mean grain diameter obtained by the regular CA model is equal to 0.173,while the magnitude calculated using the proposed optimized CA model is only 0.11.This paper proposes a novel combined CA model for simulating the microstructural evolution of 42CrMo cast steel,which notably uses a ICA-based grain topology deformation method to optimize the overlapping grain topological structures in simulation.