【摘 要】
：
The hot deformation behaviors of solution treated Mg-1.8Mn-0.4Er-0.2Al alloys were investigated by means of compression tests on Gleeble-1500 in strain rate ran
【机 构】
：
College of Materials Science and Engineering,National Engineering Research Center for Magnesium Allo
论文部分内容阅读
The hot deformation behaviors of solution treated Mg-1.8Mn-0.4Er-0.2Al alloys were investigated by means of compression tests on Gleeble-1500 in strain rate range of 0.01-10 s-1, deformation temperature range of 250-450 °C and a true strain of 0.6. The constitutive relationships among flow stress, strain rate and deformation temperature were described by Arrhenius-type equations, based on the fact that the material constants could be calculated under a wide range of strains. The results show that the flow stress of the experimental alloy decreases with temperature increasing and strain rate decreasing. Under the experimental conditions, the products of constant α and n in the constitutive equation are stable within certain strains, and the deformation activation energy ranges from 160 to 220 kJ/mol. It is proved that the values of calculated flow stress are close to the experimental results with average error of 2.01%.
其他文献
The effects of temperature on atomic anti-site behaviors in L12-Ni3(AlFe) phases were studied using microscopic phase-field dynamic model in precipitation progr
1-butyl-3-methylimidazolium perchlorate ([BMIM]ClO4) was synthesized by two steps with N-methylimidazolium. Some physico-chemical properties, such as density, s
Deep drawing is one of the most important processes for forming sheet metal parts.It is widely used for mass production of cup shapes in automobile,aerospace an
Al-Cu alloy was deformed through equal channel angular pressing (ECAP) by routes A, Ba, Bc and C up to 5 passes. ECAP was done using a 90° die for three differ
Extraction of copper and ammonia from Cu2+-NH3-Cl--H2O solution using laboratorialy synthesized sterically hindered β-diketone (4,4-dimethyl-1-(4-dodecylphenyl
Mg-6%Al-5%Pb and Mg-6%Al-5%Pb-0.55%Zn-0.22%Mn (mass fraction) alloys were prepared by induction melting with the protection of argon. The corrosion behaviors of
CuO was synthesized by thermal decomposition of Cu(NO3)2·3H2O at various temperatures and characterized by powder X-ray diffractometry (XRD) as well as scannin
Apatite coating with nanobelt structure was fabricated on single crystal silicon by a two-step method of electrodeposition at 1.0-2.0 mA/cm2 with DC power and v
10% (volume fraction) SiCp/Al-Mg composites with different Mg contents were successfully fabricated by semi-solid mechanical stirring technique under optimum pr
In order to study the effect of the withdrawing rate on carbide morphology, MC-type carbide in single crystal superalloy AM3 was systematically investigated wit