【摘 要】
：
为了改善介质阻挡放电分布形成工业水平均匀放电,研制了旋转电极介质阻挡放电装置,在高频和低频下形成带状放电分布。通过拍摄50Hz半个周期内放电照片,发现放电在半个周期内
【机 构】
：
华中科技大学电气与电子工程学院强电磁工程与新技术国家重点实验室
论文部分内容阅读
为了改善介质阻挡放电分布形成工业水平均匀放电,研制了旋转电极介质阻挡放电装置,在高频和低频下形成带状放电分布。通过拍摄50Hz半个周期内放电照片,发现放电在半个周期内形成了带状轨迹。这说明在半个周期内,放电残留物随气流流动为下游放电提供初电子,有利于形成带状轨迹分布。在工频条件下,拍摄了不同转速下的放电照片,发现随着转速增加,带状区域扩大,放电分布变得更均匀。上述现象及初步计算分析说明利用电极旋转带动放电残留物与壁电荷发生相对位移改变放电分布是成功的,为下一步实现工业应用水平上的均匀放电提供了可能性。
其他文献
A kinetic model of the piecewise-linear nonlinear suspension system that consists of a dominant spring and an assistant spring is established.Bifurcation of the
针对当前城市道路网存在的交通拥堵问题,根据城市地面交通的特点和公交优先的原则,利用广义随机Petri网通过将变迁分为时间变迁和瞬时变迁,结合禁止弧和赋予各弧不同的优先权
Based on strength reduction theory, the stability numbers of shallow tunnels were investigated within the framework of upper and lower bound theorems of limit a
The dynamic model experiment of the rock filling embankment was carried out to investigate the vibration compaction mechanism. The rock filling materials were c
To test the influence of binder strength, porous concretes with 4 binder strengths between 30.0-135.0 MPa and 5 void ra tios between 15%-35% were tested. The re
To prepare high wear resistance and high hardness coatings, electro-spark deposition was adopted for depositing an elec trode of a mixture of 92wt%WC+8wt%Co on
Cu-30Ni-xRE (x=0-0.213) alloys were prepared by a metal mould casting method. The effect of RE on the microstructure and mechanical properties of the alloys was
The discrete element method (DEM) was used to simulate the flow characteristic and strength characteristic of the conditioned sands in the earth pressure balanc
Effect of the heat treatment, including solution treatment (ST) and aging treatment (AT), on the prior austenite grain (PAG) size, microstructure and mechanical
The new 6-switch single-phase 5-level current-source inverter proposed in this paper was developed by properly simplifying the traditional 8-switch single-phase