【摘 要】
：
High cycle fatigue behavior of die cast AZ91D magnesium alloy with different Nd contents was investigated.Axial mechanical fatigue tests were conducted at the s
【机 构】
：
Key Laboratory of Advanced Structural Materials
论文部分内容阅读
High cycle fatigue behavior of die cast AZ91D magnesium alloy with different Nd contents was investigated.Axial mechanical fatigue tests were conducted at the stress ratio R=0.1 and the fatigue strength was evaluated using up-to-down load method on specimens of AZ91D with different Nd contents.The results showed that the grain of AZ91D alloy was refined,the size and amount of β-Mg17Al12 phase decreased and distributed uniformly with increasing Nd content.At the number of cycles to failure,Nf=107,the fatigue strength of AZ91D evaluated by up-to-down load method increased from 75 MPa(0.5%Nd)up to 85 MPa(1.0%Nd)and then decreased to 79 MPa(1.5%Nd),respectively.The fatigue crack of AZ91D alloy initiated at the surface defect or porosities and inclusions which existed near the surface,and propagated along the grain boundary.The fatigue crack propagation region was composed of some small facets.The clear fatigue striations appeared at the alloy of containing 1.0%Nd.The fatigue fracture surfaces of test specimens showed the mixed-fracture characteristics of quasi-cleavage and dimple.The fatigue step,trans-granular and along-granular cracks existed in the local fracture surface.
其他文献
Ce-doped ZnO films were prepared by the sol-gel method with spin coating onto glass substrates.Zinc acetate dihydrate,ethanol,diethanolamine and cerium nitrate
The cross-sectional distortion usually appears during rotary-draw bending process of thin-walled rectangular tube with small bending radius. To study the cross-
Ce-Cu-O monolithic catalysts were prepared by using Ce0.9Cu0.101.9 solid solution or nitrate as precursors,and their catalytic performance for the combustion of
Using solid-state synthesis method,a series of samples of lanthanum doped Li1-xLaxFePO4(x=0.0025,0.005,0.0075,0.01)were prepared.Each cathode structural and ele
In order to obtain the thermodynamic description of the Mg-Ga binary system, the thermodynamic assessment of the system was carried out using the CALPHAD method
The microstructure and properties of the 93W-4Ni-2Co-1Fe (mass fraction, %) tungsten heavy alloys prepared by mechanical alloying and electric current activated
With the development of aero-engine,gas import temperatures of hot section structural materials are increasingly higher.Metal alloy materials due to the rapidly
We investigated the transport properties of isoelectronic substitution of Yb by Ca for Zintl phase YbCd2Sb2 below 300 K.The p-type Yb1-xCaxCd2Sb2(0.2≤x≤0.8)sa
The β-SiC/SiO2 core-shell nanowires with the "stem-and-node" structure were synthesized in the presence of cerium oxide by the carbothermal reduction of the st
Single crystals of LaP3O9·3H2O were prepared using a classical method of aqueous chemistry whereas those of the ultraphosphate LaP5O14 were obtained by flux me