一类新的光场迭加态的高阶压缩特性

来源 :中国激光 | 被引量 : 0次 | 上传用户:gkhy0907
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
本文讨论了由光场真空态、双光子Fock态同n(n
其他文献
本文提出将银盐振幅型全息图先漂白成氯化银全息图,再经强光照射转变为银微粒位相型全息图的光分解银方法.用天津I型全息干版,衍射效率可达28%,并对光照稳定.电子显微镜照片显示出光解银的线度为0.01μm数量级,从而解释了本方法提高衍射效率的原因.
期刊
对三维光纤布拉格光栅(FBG)应变传感器的温度补偿问题进行研究,设计了新型温度补偿膜片,并采用参考光纤法对传感器进行温度补偿。实验发现,未经老化处理的裸纤在30~40℃之间会出现温度拐点,致使温度灵敏系数降低,所以封装之前必须进行老化处理。通过有限元热力分析可知,新型温度补偿膜片在-10~50℃之间自身的最大微应变约为0.073με,受热膨胀系数失配的影响较小,系统的可靠性较高。同时悬臂梁式的缓存
期刊
An effective mode selection is important for the multi-core photonic crystal fiber (PCF) to obtain good output. Talbot cavity is popular to lock the in-phase mode, but few satisfactory experimental results have been reported. In this paper, a dual-Talbot
期刊
The contrast mechanism of different polarization imaging techniques for melanoma in mouse skin is studied using both experiments and Monte Carlo simulations. Total intensity, linear polarization difference imaging (DPI), degree of polarization imaging (DO
In vivo fiber photometry is a powerful technique to analyze the dynamics of population neurons during functional study of neuroscience. Here, we introduced a detailed protocol for fiber photometry-based calcium recording in freely moving mice, covering fr
A novel miniature Fabry-Perot interferometric (FPI) temperature sensor is proposed and demonstrated experimentally. The modal interferometer is fabricated by just splicing a section of photonic crystal fiber (PCF) with a single-mode fiber (SMF). The air h
期刊
设计了工作在X波段的相对论速调管放大器同轴双间隙输出结构,并采用3维PIC程序对其进行了粒子模拟,分析了输出微波功率随直流渡越角、输出腔品质因数值等相关参数的变化,对输出腔体结构进行了优化设计。模拟结果表明:同轴双间隙输出结构可以降低束流的势能,增加束流与腔体的作用时间,提高速调管的微波提取效率。模拟中采用束压600 kV、束流5 kA、调制深度100%和峰值频率9.37 GHz的电子束以及1T的轴向引导磁场强度,得到了周期平均功率1.2 GW、峰值频率9.37 GHz、效率40%的微波输出。
Intravenous cannulation is the most important phase in medical practices. Currently, limited literature is available about visibility of veins and the characteristics of patients associated with di±cult intravenous access. In modern medical treatment, a m
基于自相似光纤激光放大技术,通过非线性光谱展宽突破光纤增益带宽的限制,结合高效色散补偿以获得高功率超短脉冲放大输出,最终得到中心波长1030 nm、重复频率40 MHz、平均功率34 W、脉冲宽度50 fs的高质量脉冲输出,对应峰值功率17 MW。该系统采用可饱和吸收体锁模,采用啁啾光纤布拉格光栅补偿腔内色散,相对于啁啾脉冲放大技术具有结构简单、集成度高等优点。实验结合光纤热管理技术和数字测控技术(FPGA),显著提升了系统的稳定性和鲁棒性,极大推动了高功率飞秒光纤激光在下游诸多科学与技术领域的应用。