论文部分内容阅读
我厂过去在调整阀动装置时,先用不动轮调整,然后再动轮求遮断点进行回动手把标示钣刻线工作,该项工作需要大量的盘车及划线工作,而质量还不可靠. 1964年我们研究试验成功“不动轮求断遮点——确定回动手把标示钣刻度线”的方法以后,给生产上带来很大好处,过去3人干,现在只要2人就行了,由过去的3小时降到现在的20～30分钟,劳动量大大减少,质量也有了保障,又充分利用了平行作业时间,缩短了总组装周期.
I used to adjust the valve actuator in the past, the first with the fixed wheel to adjust, and then move the wheel to seek off the break point to move the hand mark plate engraved line work, the work requires a lot of turning and marking work, and the quality is not reliable In 1964, after studying the successful trial of the method of “immobilizing the wheel to find out the veil - determining the hand mark of the return plate”, it brought great benefits to the production. In the past, three people were dry, and now only two people are allowed. From the past 3 hours to the current 20 to 30 minutes, greatly reducing the amount of labor, quality has also been protected, and take full advantage of the parallel operation time and shorten the total assembly cycle.