计量故障自动监测一直是营销工作的重点、难点,在没有建立电能信息采集系统的时候,主要靠抄表员和电能表维护人员现场检查或线损分析人员自行判断,时间长,难以全面覆盖,容易造成大的电量追补。各地市在建立负荷管理系统后,通过分析负荷管理系统采集的电压、电流来判断是否存在计量故障,与过去靠人工现场巡视比较,监测手段有所提高。但由于受通信条件的制约,230M通信的电能信息采集终端无法定时采集24个点的 Automatic measurement of fault monitoring has been the focus of marketing efforts, the difficulty, in the absence of the establishment of electric energy information acquisition system, mainly by the meter and meter maintenance personnel on-site inspection or line loss analysis staff to judge, a long time, it is difficult to fully cover, Easily lead to a large amount of power to recover. After setting up the load management system in all localities and municipalities, the voltage and current collected by the load management system are used to judge whether there is a measurement fault or not. Compared with the previous manual inspection, the monitoring methods have been improved. However, due to the constraints of communication conditions, 230M communication power information collection terminal can not regularly collect 24 points