论文部分内容阅读
车用燃气轮机陶瓷零件的研制——(Hagemeister.K)《MotortechnischeZeitschrift》1983,44,4,S.133—137(德文)本文叙述了德意志联邦共和国研究与发展部关于研制燃气轮机耐高温陶瓷零件的发展计划。计划规定要研制功率分别为100、150、300瓩三种燃气轮机。文中例举了由陶瓷材料做成的燃气轮机零件有燃烧室,进气口锥面,燃气轮机的定子和转子等。研究表明,用计算法可以确定在负荷改变时,陶瓷材料的性能对导向叶片的影响;用试验来澄清了叶片破坏速度与叶片表面状况的关系。图15幅,表1个,参考文献1种。(戴雄杰摘)用扫描电镜对磨损状态的诊断——(Nittel.J等)《Schmierungstechnik》.1983,№.196—198(德文)本文阐述了用扫描电镜对磨损状态进行诊断的可能性和优越性。指出,在许多情况下对磨损的表面状况和其组织的评定
Development of Automotive Gas Turbine Ceramic Parts - (Hagemeister.K) “Motortechnische Zeitschrift” 1983, 44, 4, S.133-137 (German) This article describes the research and development department of the Federal Republic of Germany on the development of high temperature ceramic parts for gas turbines Development Plan. The plan provides for the development of three gas turbines with power ratings of 100, 150 and 300 别 respectively. In this paper, the gas turbine parts made of ceramic material are exemplified by the combustion chamber, the air inlet cone, the stator and the rotor of the gas turbine, and the like. The results show that the influence of the performance of the ceramic material on the guide vane can be determined by the calculation method. The relationship between the vane destruction rate and the surface condition of the vane is clarified by the test. Figure 15, Table 1, a reference. (Dai Xiongjie Pick) Diagnosis of wear status with SEM - (Nittel.J et al.) “Schmierungstechnik” .1983, No. 196-198 (German) This article describes the possibility of diagnosing wear status with scanning electron microscopy And superiority. Indicate, in many cases, the assessment of worn surface conditions and their organization