车削钢件时, 会产生一根相当长 的带状切屑。加工 铝制飞机轮子端面 时,从外径到中心, 也会产生同样的切 屑。这种切屑,不 但对工人极不安 全,容易造成割伤 事故。同时,由于 切屑的甩动,还会 发生崩刀和损坏工 件已加工表面的光 洁度。为了使工作 得以正常进行,经 常迫使工人停 When turning a steel piece, it produces a fairly long band of chips. When machining the face of aluminum aircraft wheels, the same cuttings are produced from the outside diameter to the center. This kind of swarf is not only extremely unsafe for workers, but also can easily cause cuts. At the same time, chipping and damage to the finished surface of the work piece can occur due to chip lashing. In order to make work work normally, workers are often forced to stop