论文部分内容阅读
The effect of heating and cooling rate on the microstructure and mechanical properties during anneal
【机 构】
：
Department of Materials Science and Engineering,Norwegian University of Science and Technology,Norwa
【出 处】
：
第9届计算纳米科学与新能源材料国际研讨会
【发表日期】
：
2016年3期
其他文献
In this paper,experimental study on heat transfer performance of fin-tube heat exchanger and PSHE(primary surface heat exchanger)used in waste heat recovery is proceeded.The objective of this study is
会议
The purpose of this study was to compare the performance characteristics of conventional manifold of solar collectors and manifolds that are fabricated by the application of hydroforming technology.Ex
会议
In the US building sector,commercial energy use is the largest end use consuming more than nighteen quintillion Joules of source energy annually.A few studies using simulation tools to calculate build
会议
Downward two-phase flow of air and water in narrow rectangular channel has been investigated.The channel is 66.7,2.35 and 780 mm in width,gap and height,respectively.
会议
Melting in a binary solution is an important phenomenon both in environmental and engineering fields.Such melting phenomena are caused by concentration and the temperature gradient.Therefore,they are
会议
MICROCLIMATE MODELLING OF TYPICAL LAND USE UNITS WITH DIFFERENT ARRANGEMENTS:A CASE STUDY IN LANGFAN
The deterioration of urban environment has a closely relationship with the functions of land use.The stagnant wind conditions in compact urban areas may also exacerbate the local environment.Instead o
会议
Thanks to advance in permanent magnet synchronous motors(PMSM)and power electronics,the household axial-type fans,such as standing fans or ceiling fans can be operated in wider speed range by using in
会议
Air-conditioning ducting has been found to be paths of smoke spread in case of fire.The interaction of air-conditioning operation and smoke exhaust has been found to be a risk factor for safe egress f
会议
In this study,condensing heat transfer in quadrilobed tubes used for a heat pump system was experimentally investigated.HFC-134a was used as the refrigerant.The effect of the tube configuration on the
会议
STUDY ABOUT OPTIMIZATION OF AN ALUMINUM MICRO CHANNEL HEAT EXCHANGER PERFORMANCE FOR HEAT PUMP AIR-C
An aluminum micro channel heat exchanger is getting replaced for a fin and tube heat exchanger used for an air-conditioner from the purpose of high performance and compactness.A heat exchanger for hea
会议