论文部分内容阅读
Microstructure Evolution and Growth Orientation of Directionally Solidified Mg-4 wt％ Zn Alloy with D
【出 处】
：
金属学报（英文版）
【发表日期】
：
0年期
其他文献
Tribological Behaviors of Ni3Al Intermetallics with MoO3 Multilayer Ribbon Crystal Prepared by Spark
This study reports that small amounts of MoO3 multilayer ribbon crystal (MoO3 MLRC) in Ni3Al intermetallics showed the decreased friction coefficients and improved wear resistance at different contact loads.Specifically,the friction coefficients (0.32-0.3
Microstructure and Properties of the Cr-Si-N Coatings Deposited by Combining High-Power Impulse Magn
The Cr-Si-N coatings were prepared by combining system of high-power impulse magnetron sputtering and pulsed DC magnetron sputtering.The Si content in the coating was adjusted by changing the sputtering power of the Si target.By virtue of electron-probe m
Magnesium and calcium phosphates composites are promising biomaterials to create biodegradable load-bearing implants for bone regeneration.The present investigation is focused on the design of an interpenetrated magnesiumtricalcium phosphate (Mg-TCP) comp
Effect of Milling Tools on the Microstructure and Property of Cu-Based Composites Prepared by Mechan
Cu and Nb powders were used as starting materials to produce Cu-Nb and Cu-NbC-WC composites by mechanical alloying.X-ray diffraction,scanning electron microscopy,transmission electron microscopy observations and microhardness measurements have been used t
Effect of HIP Treatment on Fatigue Crack Growth Behavior of Ti-6Al-4V Alloy Fabricated by Electron B
The effect of hot isostatic pressing treatment on the fatigue crack growth behavior of Ti-6Al-4V alloy fabricated by electron beam melting was investigated.The results indicate that the fatigue crack growth rate of the HIPed samples is higher than that of
Dynamic Mechanical Behavior and Hypervelocity Impact Performance of an Al-Based Nanocrystalline Allo
In a wide strain rate range from 10-5 to 103 s-1,the deformation behavior of an Al-based nanocrystalline alloy was investigated.After fracture,the debris collected was used for statistical analysis,which is expected to reflect the profile of the fracture
Characterization of Prealloyed Ti-6Al-4V Powders from EIGA and PREP Process and Mechanical Propertie
Prealloyed Ti-6Al-4V powders were prepared by electrode induction melting gas atomization (EIGA) and plasma rotating electrode process (PREP) in this work.A comparative study of EIGA and PREP powders for hot isostatic pressing (HIPing) compaction was cond
Effects of W Addition on the Electrochemical Behaviour and Passive Film Properties of Fe-Based Amorp
The electrochemical behaviour and passive film properties of Fe-Cr-Mo-W-C-B-Y amorphous alloys in acetic acid solution were investigated.The potentiodynamic polarisation and Nyquist curves demonstrated that W addition significantly enhanced the corrosion
Corrosion Behavior of Cupronickel Alloy in Simulated Seawater in the Presence of Sulfate-Reducing Ba
The corrosion behavior of cupronickel alloy immersed in the simulated seawater in or without the presence of sulfate-reducing bacteria (SRB) was studied.The results of scanning electronic microscopy and electrochemical impedance spectra reveal that corros
Four CrAlN coatings with various Al content were prepared by arc ion plating technology under different target currents.The effect of the Al content on the microstructure,chemical compositions,element chemical bonding states and mechanical properties of t