乌鲁木齐铝厂铝冶炼原来采用的是一万安培电流小电解槽。工艺技术落后,容量小、产量低、耗能大、成本高。工人劳动强度大,环境污染严重,经济效益差,连年亏损。到1982年累计亏损1025万元,平均每年国家财政补贴85万元,处在关停并转的关键时刻。三中全会后,在党的工作重点转移和各项经济政策指引下,我们坚持挖潜、革新、改造的方针,在自治区财政厅的支持下,1980年贷款65万元,对园铝杆的生产工艺进行了改造,由液体铸杆改为连铸连轧,产能提高十二倍,质量达到国家标准,成本下降5.3％。特别是铝电 Urumqi aluminum smelter aluminum used in the original ten thousand ampere current cell. Technological backwardness, small capacity, low output, energy consumption, high cost. Labor intensity, serious environmental pollution, poor economic efficiency, loss year after year. To 1982, the cumulative loss of 10.25 million yuan, the average annual state subsidies of 850,000 yuan, at the crucial moment of closure and transfer. After the Third Plenary Session of the Plenary Session of the CPC Central Committee, under the guidance of the party’s work shift and various economic policies, we insisted on the principle of tapping potential, reforming and rebuilding. With the support of the autonomous regional finance department, we made a loan of 650,000 yuan in 1980, Process was transformed from liquid cast rod into continuous casting and rolling, productivity increased by 12 times the quality of the national standard, the cost dropped 5.3%. Especially aluminum