论文部分内容阅读
南通农药厂亚磷酸三甲酯车间原设计年产600吨,后改为1600吨,厂房建筑面积为1400平方米,该车间自1983年8月1日开始试桩,1984年4月底完成土建基础施工图,1985年1月厂房基本建成,经施工检验土建基础设计得到好评,现简介如下: 一、工程概况本车间为现浇钢筋混凝土框架结构,长63m,宽10.5m,并附设罐区带10m,厂房最高三层,总高17m,车间的五分之四位于深约4m左右的暗浜上,填土质量差,除主要亚粘土外,还混有砖块、垃圾和杂物,柱基荷重
The Nantong Pesticide Factory’s trimethyl phosphite plant was originally designed to produce 600 tons per year, and was later changed to 1600 tons. The plant construction area was 1,400 square meters. The workshop began trial piles on August 1, 1983 and completed the civil engineering foundation at the end of April 1984. The construction drawings, basically completed in January 1985, were well-received by the civil construction design of the construction inspection. The brief introduction is as follows: I. Project Overview The workshop is a cast-in-site reinforced concrete frame structure, 63m long and 10.5m wide, with a tank zone attached. 10m, the factory is the highest three floors with a total height of 17m. Four-fifths of the workshop is located on a dark concrete about 4m deep. The quality of the filling is poor. Apart from the main sub-clay, it is also mixed with bricks, garbage and debris. Baseload