论文部分内容阅读
1.起动电动机的使用和保养(1)起动电动机在装入主机时,应将凸缘平面及发动机上相应安装面的防锈油及残漆等除去,使其接触良好;否则起动机会因接铁不良而不易起动。(2)起动机在安装时,必须保证接合器齿轮轴线与飞轮齿圈轴线平行,不允许偏斜,否则会引起打牙及咬牙等现象。(3)起动电动机接蓄电池的铜导线截面,一般要求不小于25平方毫米;而接开关的铜导线截面则不小于4平方毫米。同时导线长度应尽可
1. Start-up motor use and maintenance (1) start the motor into the host, the flange plane and the engine should be installed on the appropriate anti-rust oil and paint and other removal, so that good contact; otherwise the starter will be due to access Bad iron and not easy to start. (2) When the starter is installed, the axis of the gear must be parallel to the gear ring axis of the flywheel. Skew should not be allowed. Otherwise, it will cause tooth-striking and gritting. (3) Starting the motor connected to the battery copper wire cross-section, the general requirements of not less than 25 square millimeters; and then the switch copper wire cross-section is not less than 4 square millimeters. At the same time the length of the wire should be as much as possible