使用前的准备工作脱粒作业开始前先要安装好机具和原动机,挂好机器上的三角胶带,并对机器进行检查调整。 1.安装机具机具应安装在平坦的场地上,使机器的纵向和横向保持水平位置,不许摇(扌晃),并应顺风问放置。在铺放台的左侧可以接长木板,应与铺放台等高。 2.安装原动机以J03-31—4电动机为动力。安装时拆去脱粒机后下部的电动机罩壳,把预先装好顶 Preparation before use Threshing operation Before starting, install the implement and prime mover, hang the triangle tape on the machine, and check and adjust the machine. 1. Installation of machinery and equipment should be installed on a flat site, so that the machine vertical and horizontal to maintain horizontal position, not allowed to shake (扌 Akira), and should be placed downwind. In the laying of the left side of the bench you can then access the long board, should be placed with Taiwan and other high. 2. Install the prime mover with J03-31-4 motor as power. Remove the threshing machine after the installation of the lower part of the motor cover, the pre-installed roof