论文部分内容阅读
由于机泵大小不同,重量各异,所以采用的垫铁也大小不一。在计算两轴不同轴度调整尺寸时,通常都是以垫铁的宽度中心来计算的,这在计算水平方向的调整尺寸时是毫无差错的。但是,在计算垂直方向的调整尺寸时,由于垫铁宽度的影响就产生了误差,结果造成拖延工期,有时也影响工程质量,为此施工中必须精确计算,排除垫铁宽度的影响。一、垫铁宽度的影响与排除在计算机泵支座点的调整尺寸时,无论使用什么方法,什么公式,通常都是按支座(垫钱,中心用 OD_1、OD_2尺寸进行计算的,从1～3图中看出,OD_1、OD_2尺寸是不准确的,其误差值受 d/2(垫铁宽度的一半)的影响。
Due to the different pump size, weight, so the size of the horn is also different. Calculating the misalignment of two axes is usually calculated from the width center of the horn, which is error-free when calculating the horizontal resizing. However, when calculating the vertical dimension, errors will occur due to the width of the horn. As a result, the delay period and sometimes the quality of the project will be affected. Therefore, the construction must accurately calculate and eliminate the influence of the horn width. First, the impact of horn width and the exclusion of the size adjustment of the computer pump support point, no matter what method is used, the formula is usually based on the support (pad money, the center OD_1, OD_2 size calculation, from 1 ~ 3 figure shows, OD_1, OD_2 size is not accurate, the error value by d / 2 (horn width half) impact.