【摘 要】
：
The surface modification of magnesium alloys (AZ31 and AZ91HP) was studied by a high current pulsed electron beam(HCPEB). The results show that the cross-sectio
【机 构】
：
School of Materials and Metallurgy,State Key Laboratory for Materials Modification by Laser
论文部分内容阅读
The surface modification of magnesium alloys (AZ31 and AZ91HP) was studied by a high current pulsed electron beam(HCPEB). The results show that the cross-sectional microhardness of treated samples increases not only in the heat affected zone(HAZ), but also beyond HAZ, reaching over 250 μm. This is due to the action of quasi-static thermal stress and the shock thermal stress wave with materials, which result in its fast deformation on the surface layer and so increases microhardness. For the AZ91HP alloy, a nearly complete dissolution of the intermetallic phase Mg17Al12 is observed, and a super-saturated solid solution forms on the re-melted surface, which is due to the solute trapping effect during the fast solidification process. Measurements on sliding wear show that wear resistance is improved by approximately 5.6 and 2.4 times for the AZ31 and AZ91HP respectively, as compared with as-received samples.
其他文献
An in-situ TiCP/Al composite was prepared by a thermal explosion/quick pressure method (TE/QP). The effect of Al content on the reaction temperature as well as
A new iris feature extraction approach using both spatial and frequency domain is presented. Steerable pyramid is adopted to get the orientation information on
A comprehensive stochastic model for simulating microstructure formation of Ti-45 % Al(mole fraction)alloy ingot during solidification process was developed, ba
This paper presents a type system, called Location System (L-S), to control the interferences in the ambient-like calculi. The L-S allows well-behaved (non-inte
It is demonstrated that the nickel can be deposited directly on the surface of carbon nanotubes without pre-sensitization by Sn2+ and Pd2+ in a watt bath contai
A new linear integration was developed. First, effective strain rate for slab forging with bulge was expressed in terms of two-dimensional strain rate vector, a
The anomalous photovoltaic effect was studied in epitaxial La0.8Sr0.2MnO3 films by laser molecular beam epitaxy. It is demonstrated that the signal polarity is
Eu-doped silicate complex gel nano-particles was obtained by sol-gel process and characterized with TEM, XRD, PL, etc. The well dispersed particles have particl
The evolution of phase compositions, phase change and microstructure in Sm2Fe17 alloys during hydrogenation-disproportion process were systematically studied wi
以某造纸企业废水治理工程为研究对象。具体介绍了“混凝气浮一生物接触氧化法”工艺的具体流程和技术特点，实践表明：该工艺具有一定的先进性，处理后水能达到国家污水二级排放标