论文部分内容阅读
Abnormal relationship between rust particles size and rust layer compactness of weathering steels
【机 构】
：
School of Materials Science and Engineering,University of Science and Technology Beijing,Beijing 100
【出 处】
：
金属学报（英文版）
【发表日期】
：
2010年1期
其他文献
The Mg-8Sn-4Zn-2Al (TZA842,in wt％) alloys with different initial microstructure (as-cast-AC and homogenization treatment-HT) subjected to hot extrusion.Also,the strengthening responses to AC and HT for the extruded TZA842 alloys were reported.The results
Effect of Heat Treatment on Microstructure and Mechanical Properties of Quenching and Partitioning S
In order to investigate the effect of microstructural characterization on the mechanical properties and retained austenite stability,a different type of quenching and partitioning steel (I-Q&P) through intercritical annealing before the quenching and part
Spherical Nb-20Si-24Ti-2Cr-2Al pre-alloyed powders were processed by selective laser melting (SLM) on Ti6Al4V substrates with different energy densities.A series of single tracks and single layers were produced using different processing parameters,includ
In order to investigate the microstructure and mechanical property evolution of low-carbon reduced activation ferritic/martensitic (RAFM) steel during isothermal aging,the normalized and tempered specimens were aged at 600 ℃ for 500,1000,and 3000 h,respec
A multi-phase-field model has been developed to simulate the microstructure evolution and kinetics of the austenite static recrystallization (SRX) in a C-Mn steel.In this model,the bulk free energy that coupling the deformation stored energy with a specia
Influence of Island Scanning Strategy on Microstructures and Mechanical Properties of Direct Laser-D
To investigate the influence of island scanning on the microstructures and mechanical properties of direct laser-deposited Ti-6Al-4V structures,two samples are prepared using island scanning and orthogonal successive scanning,respectively.The microstructu
In this work,a quaternary Ni-Cu-Nb-Ta system has been designed to obtain composite microstructure with spherical crystalline Cu-rich particles embedded in amorphous Ni-rich matrix.The alloy samples were prepared by using singleroller melting-spinning meth
This paper is to represent new algorithms to predict process parameters on top-bead width in robotic gas metal arc(GMA) welding process.The models have been developed:linear, curvilinear and intelligent model based on full factorial design with two replic
Hot processing behavior of an ultra-high-strength Fe-Ni-Co-based maraging steel was studied in temperature range of 900-1200 ℃ and strain rate range of 0.001-10 s-1.Deformation processing parameters and optimum hot working window were characterized via fl