论文部分内容阅读
事故过程2006年3月15日15时,某化工厂合成车间熔硫岗位操作工蒋某,在向熔硫釜内加入硫磺泡沫液过程中,发现压力升高,即开排清液阀门向回收池内排清液。此时,清液沉降槽正因清除沉碴而停用,排清液管口接着一节3m长的旧消防水带。由于蒋某把排清液的阀门开得过大,接管的消防水带摆动出回收清液池外,蒋某不假思索地赶过去牵拉水带,想重新放入回收池内。不料,摆动的水带溅出的少量热清液(含碱)溅到他的面部和颈部,致其烫灼伤。在对蒋某受伤处进行一番清水冲洗后,为慎重对待,又将其送医院救治。
Accident process At 15:00 on March 15, 2006, a chemical plant synthetic sulfur workers in the workplace SM Jiangmou, adding sulfur in the molten sulfur reactor foam liquid process and found that the pressure rises, that is, to open a clear liquid valve to the recovery Clear liquid inside the pool. At this point, clear liquid settling tank is due to remove the ballast and disabled, clear liquid pipe mouth followed by a section of 3m long old fire hose. Jiangmian clear the liquid valve to open too much to take over the fire hose swinging out of recovery of liquid pool, Jiang unreasonable to catch the past to pull the water, want to re-put into the recovery pool. Unexpectedly, a small amount of hot liquid (alkali) splashed by the oscillating water splashed onto his face and neck, causing it to burn. Jiangmou injury at a clean water rinse, to be treated with caution, and then sent to the hospital for treatment.