【摘 要】
：
To increase the adhesion strength between the coating and the substrate, sintered Ti(C,N)-based cermets were selected and deposited with monolayer TiN using a m
【机 构】
：
State Key Laboratory of Die & Mould Technology,School of Electromechanical Engineering
论文部分内容阅读
To increase the adhesion strength between the coating and the substrate, sintered Ti(C,N)-based cermets were selected and deposited with monolayer TiN using a multiarc ion-plating technique; subsequently, hot isostatic pressing (HIPing) treatment was performed at 1000℃ using nitrogen pressure up to 110 MPa. The mechanical properties of cermets after a coating process and subsequent HIPing treatment have been evaluated with respect to the hardness, the residual stress, and the coating adhesion. The results show that after the HIPing process, there was a higher increase in critical load in the TiN-coated cermets with lower surface roughness compared with those with higher surface roughness. In all cases, the residual stress was found to be compressive. The effects of substrate surface roughness and posttreatment on the adhesion strength of the coatings were thus investigated. It was also found that the HIPing posttreatment process is well suited for increasing the adhesion strength between the coating and the substrate.
其他文献
全员绩效管理是为了促进员工绩效提升并促进供电企业战略目标实现采用的管理方式。全员绩效管理是企业实现整体战略的强大的支撑,是转变企业管理模式的重要措施,有利于企业文
企业经济管理模式与企业效益密切相关,通过探索企业经济管理的规范化方法,不仅有助于为企业赢得更大的经济效益,推动企业的可持续发展,而且对现代企业经济管理制度的建立具有
Nanometer Ni0.5Zn0.5Fe2O4 powders with spinel phase were prepared by the hydrothermal method using purified FeSO4 solution from sodium jarosites slag as materia
In the process of 2-D compressional wave propagation in a rock mass with multiple parallel joints along the radian direction normal to the joints, the maximum p
Spherical cobalt carbonate with high tap density, good crystallization and uniform particle size was prepared by controlled chemical crystal method using cobalt
The lubrication effectiveness of the composite lubricants, 50wt% ethylene bis-stearamide (EBS) wax + 50wt% graphite and 50wt% EBS wax + 50wt% BN, during the pow
This article reports the study on acid equilibrium during bioleaching of alkaline low-grade copper sulfide ore.Adding auxiliary agents 1# (sulfur) and 2# (pyrit
Particulate TiC reinforced 17-4PH and 465 maraging stainless steel matrix composites were processed by conventional powder metallurgy (P/M). TiC-maraging stainl
在新的历史条件下,烟草员工所面临的生活和工作压力越来越大,挑战越来越多,新情况、新问题层出不穷,新事物、新观念应接不暇,导致各种心理问题随之增加。如何让烟草员工在物
La(Mg1-xAlx) (x=0.2,0.4,0.6,0.8) alloys have been prepared using induction melting followed by annealing. It is found that partial substitution of Mg by Al does