论文部分内容阅读
工業厂房建筑对設計与施工的要求較高,不論設計上的錯誤,或者施工中的疏忽,以及材料質量的不合規格,均会影响工程質量。在过去几年中,我們也经常遇到一些質量問題,我們对各部分構件也曾經采取了一些加固措施,这些措施均已經受过一段时期的考驗,证明是行之有效的。本文下面就介绍其中的几种: 一屋面板支承長度不夠的补强由于屋面板制作的長度不准确和屋架及柱子安裝时的偏差(例如某工程中的屋架,最大偏差达13.5公分,柱子偏差达14.5公分),往往造成屋面板在屋架或屋面大梁上的擱置長度不够的現象,一般都相差4～5公分,少者也有2公分;这就使得屋面板与屋架
Industrial plant buildings have high requirements for design and construction. Regardless of design errors or negligence in construction or substandard material quality, the quality of the project will be affected. In the past few years, we have also encountered some quality problems. We have also taken some reinforcement measures for each component. These measures have been tested for a period of time and have proved to be effective. Here are some of the following: Insufficient support length for a roof slab Due to the inaccurate length of the roof slab and the deviation of the roof frame and pillar installation (for example, the truss in a project, the maximum deviation is 13.5 cm, the column deviation Up to 14.5cm), which often results in the length of the roof plate not being put on the truss or the roof girder, which is generally 4 to 5 centimeters apart, and 2 centimeters for the lesser ones; this makes the roof panels and trusses