隔板和端头板是P3015模板的两个零件(见图1),板厚为2.5mm,原来用整体落料模落料,不但冲裁废料多(见图2),而且凹模变形后难以修复,为此,我们将模具改成图3所示的结构。一、工作过程先用剪板机把板剪成52_(-0.5)~0mm宽的条料,调直后再把它送入模具,由剪刃7剪切齐头。同时,由凸模1或3冲豁,由凸模2、6冲孔。当条料继续送进到挡板14时,就由剪刃7剪断,这时第一块端头板或隔板就冲裁完毕并落下。在剪断的 Partition and end plate P3015 template is the two parts (see Figure 1), the thickness of 2.5mm, the original blanking blanking blanking, not only blanking scrap more (see Figure 2), and after the deformation of the die Difficult to repair, therefore, we will die into the structure shown in Figure 3. First, the working process First cut the board with a shears 52 _ (- 0.5) ~ 0mm wide strip, straightened and then send it into the mold, cut by the cutting edge 7 Qi. At the same time, punched by the punch 1 or 3 punched by the punch 2,6. When the material continues to be fed to the baffle 14, it is cut by the cutting edge 7, when the first end plate or baffle is punched and dropped. Cut in