我厂铸工车间抛丸室的走台小车,由减速箱传动改为用钢丝绳牵动,收到非常满意的效果。过去在小车中间装有一个减速箱,电机通过减速箱驱动小车运动。这样的装置,表面看似乎讲究,但很不适合在清理工作场所,不是进灰,就是进砂,经常出现停车故碍。改进后的传动原理如下图所示:电机9通过皮带轮8、10和齿轮12、13带动V形轮7转动,在V形轮上的Ф15钢丝绳,通过导向轮1连接在小车两端,驱动小车移动。 Casting plant in our factory shot blasting room walk Taiwan car, by the gearbox drive with wire rope affects, received very satisfied results. In the past in the middle of the car equipped with a gear box, the motor drive through the gear box movement. Such devices, the surface seems to pay attention to, but it is not suitable for cleaning the workplace, not into the ash, is into the sand, frequent parking problems. The improved transmission principle is shown as follows: The motor 9 drives the V-shaped wheel 7 to rotate through the pulleys 8 and 10 and the gears 12 and 13, and the Ф15 steel wire rope on the V-shaped wheel is connected to both ends of the car through the guide wheel 1 to drive the car mobile.