论文部分内容阅读
介绍了Carrousel卷取机在冷连轧机组中的布置位置和工作原理。研究了Carrousel卷取机主要参数的设计方法。分析了大转盘结构参数和减速比的确定方法;对卷筒电机功率公式中张力和速度组合问题进行了分析计算;分析推导了涨缩缸平衡力的计算公式。编制了Carrousel卷取机的动作控制流程图,阐述了Carrousel卷取机的控制要求。在研究的基础上,提出Carrousel卷取机参数设计时应注意的问题和控制的原则。
The location and working principle of Carrousel coiler in tandem cold rolling mill are introduced. The design method of the main parameters of the Carrousel winder was studied. The method to determine the structure parameters and reduction ratio of the large turntable is analyzed. The combination of tension and speed in the power formula of the drum motor is analyzed and calculated. The formula for calculating the balance force of the cylinder is analyzed. The flow chart of the operation control of the Carrousel coiler was compiled and the control requirements of the Carrousel coiler were expounded. On the basis of the research, the problems that should be paid attention to when designing the parameters of Carrousel coiler and the principle of control are put forward.