钢模板在施工时,一般是用螺栓对穿钢模板,在模板两面夹住固牢。因此,拆模后模板上残留着很多的孔洞,模板再次使用时,必须将孔补好。但模板补洞一直没找到较好的方法。用焊锡补洞,浪费材料,进度慢;用木楔塞洞不牢固,质量也没用保证。 When the steel formwork is under construction, the steel formwork is generally bolted to the steel formwork and clamped firmly on both sides of the formwork. Therefore, many holes remain on the template after the mold is removed. When the template is used again, the holes must be repaired. However, the template hole has not found a better way. Filling holes with solder, wasting material, progress is slow; holes are not solid with wooden wedges, and quality is no guarantee.