【摘 要】
：
In this work,the corrosion behavior of medium-carbon steels(45,45Cu and 45Cuq steels)in acidic chlo-ride environment was investigated.The results indicated that the micro-galvanic effect between the anodic ferrite matrix phase and the cathodic cementite s
【机 构】
：
Shenyang National Laboratory for Materials Science,Institute of Metal Research,Chinese Academy of Sc
论文部分内容阅读
In this work,the corrosion behavior of medium-carbon steels(45,45Cu and 45Cuq steels)in acidic chlo-ride environment was investigated.The results indicated that the micro-galvanic effect between the anodic ferrite matrix phase and the cathodic cementite secondary phase notably affected the corrosion resistance of the three steels.For 45 steel,serious pitting corrosion happened in and around the pearlite regions,and a large number of lamellar cementite was fixed in the corrosion pits.Meanwhile,the contin-uously increasing superficial area of cathodic cementite enhanced the micro-galvanic corrosion,resulting in a rapidly increase in corrosion rate with time.While for 45Cu and 45Cuq steels,macroscopic uniform corrosion occurred,and the cementite accumulation was markedly reduced as compared with 45 steel,thus the micro-galvanic effect was weakened and the corrosion rate was decreased accordingly.Among these,45Cuq steel showed the most stable and excellent corrosion resistance during long-term corro-sion,indicating the occurrence of a synergistic effect between cementite spheroidization and Cu alloying,thereby significantly improving the corrosion resistance of 45 steel.
其他文献
The worldwide outbreak of COVID-19 since December 2019 has caused great challenges to health organizations,and brought tremendous impact on the global economy.There have been over 62.3 million confirmed infection cases and 1.4 million deaths reported unti
Gradient boosting decision tree(GBDT)machine learning(ML)method was adopted for the first time to automatically recognize and conduct quantitative statistical analysis of boundaries in bainitic microstruc-ture using electron back-scatter diffraction(EBSD)
Increasing iron content has been witnessed an essential method to improve the remanence of 2:17-type Sm-Co-Fe-Cu-Zr magnets,however,the inferior squareness factor accompanied with the increased iron content turns into a neck sticking problem.In this work,
Layered lithium nickel-cobalt-manganese oxides(NCM)have been highlighted as advanced cathode materials for lithium-ion batteries(LIBs);however,their low interfacial stability must be overcome to ensure stable cycling performance of the cell.In this work,w
Na3(VO)2(PO4)2F(NVPOF)has been considered as one potential candidate for sodium-ion batteries because of its high operating voltage and theoretical capacity.However,the poor intrinsic electronic conductivity significantly restricts its widespread applicat
The controllable adjustment of electromagnetic(EM)properties for high-efficiency EM absorbents are indispensable,nonetheless,rare in crystals engineering regulation.Herein,for the first time,regulated amount of sodium citrate was employed as accessory lig
The influence of particle size and morphology on grain refinement in low stacking fault energy(SFE)alloys was studied by comparing the grain structures in single-and multi-phase Al-bronze(AB)alloys following equal channel angular pressing(ECAP)between 350
The effects of site occupation on the phase stability,martensitic transformation,and the magnetic and electronic properties of a full series of Ni-Mn-In alloys are theoretically studied by using the ab initio calculations.Results indicate that the excess
Oxide dispersion strengthened CoCrFeMnNi high-entropy alloys(ODS-HEAs)were prepared using two different powder preparation methods classified by yttrium addition strategy to investigate the effects of in-situ and ex-situ oxide dispersoid formation on the