加工小批量摆线轮的轮齿在没有专用设备的情况下,可以根据摆线展成原理和行星传动轮系的动作原理,在立铣床上附加加工摆线轮的机构来实现。该装置应使加工件(摆线轮)、底盘、销轴(输出轴)、偏心轴系(系杆件)和特定棒铣刀(针齿)符合上述原理和动作联系,从而得到正确的变态摆线等距曲线的齿形。为此,在立铣床的纵向工作台上装上一回转工作台(如下图所示),并通过回转工作台中心孔,安装一根可自由回转的偏心轴,再将底盘固定在回转工作台 In the absence of special equipment, the gear teeth of the small batch cycloid wheel can be realized by the mechanism of adding the cycloidal wheel on the vertical milling machine according to the principle of the cycloid and the action principle of the planetary transmission wheel train. The device should make the workpiece (cycloid), chassis, pin (output shaft), eccentric shaft (tie rod) and the specific rod cutter (pin teeth) in line with the above principles and actions to get the correct metamorphosis Toothed equidistant curves. For this purpose, a rotary table is mounted on the vertical table of the vertical milling machine (as shown in the figure below). A free-pivoting eccentric shaft is installed by rotating the center hole of the table, and the bottom plate is fixed on the rotary table