框架结构砖隔墙的拉结筋是在钢筋混凝土柱上预埋。以前大多采用的预埋方法是在柱模上钻孔插筋,这种方法的效果不佳,下面介绍一种新方法,见下图。先按设计要求制作好拉结筋,拉结筋伸进砖墙一端暂不做180°弯钩,以便浇完混凝土后容易拉比来。再在已配好的柱模上弹出砖墙位置线,依照砖墙位置线及拉结筋的设计间距, Pulleys for framed brick partitions are embedded in reinforced concrete columns. The pre-embedding method that was mostly used before was to drill holes in column molds. This method has poor results. The following describes a new method. See the figure below. Firstly, according to the design requirements, we must make the buckwheat ribs, pull the ribs into the end of the brick wall, and do not do the 180° hook at the end, so that the concrete can be pulled easily after pouring. Then pop up the brick wall position line on the already fitted column mold, according to the design distance between the brick wall position line and the pull ribs.