论文部分内容阅读
1.脱粒机应放在运输方便、地面平坦、通风良好的场地上。2.脱粒机安放时要注意风向,喂入口要放在上风头,出草口和排糠口要放在下风头。3.对各转动部件要加油保养,各部紧固螺钉要按规定的扭矩上紧,滚筒旋转方向应和上盖所标箭头方向一致。4.脱粒前要进行空运转,看有关部件连接是否牢固,转动是否平稳,确无异常情况,方可投入作业。5.脱粒机防护罩安装要牢固,破损的应及时修理,其铁皮厚度不应小于1.2毫米。6.三角带松紧要适当,过紧过
1. Threshing machine should be placed on a convenient transportation, the ground is flat, well ventilated venues. 2. Threshing machine placement should pay attention to the wind, the feed port should be placed on the limelight, the grass mouth and row of mouth to be placed under the limelight. 3. The rotating parts to be refueling and maintenance, the Ministry of fastening screws to tighten the provisions of the torque, drum rotation direction and direction of the arrow marked by the superstructure. 4. Threshing before the air run to see if the connection is solid parts, rotation is smooth, there is no abnormal situation, can be put into operation. 5. Thinner guards installed to be solid, damaged and promptly repaired, the thickness of the metal should not be less than 1.2 mm. 6. V-belt to be tight, too tight