Dimensions of one kind of stainless steel plate before finish rolling were obtained through analysis of the rough rolling processes by finite element method and updated geometrical method.The FE models of finish rolling process with a front edge roll were built,and influences of the edge rolling reduction on the stress change in the plate edge during finish rolling were analyzed.The results show that when the edge rolling reduction is increased from 0 mm to 2 mm,the compressive stress in plate corner clearly increases in edge roiling process,and the zone of tensile stress during whole rolling decreases;when the edge rolling reduction is increased from 2 mm to 5 mm, the compressive stress in the plate corner seldom changes,and the compressive stress decreases after the horizontal rolling. Dimensions of one kind of stainless steel plate before finish rolling were obtained through analysis of the rough rolling processes by finite element method and updated geometrical method. The FE models of finish rolling process with a front edge roll were built, and influenced by the edge rolling reduction on the stress change in the plate edge during finish rolling were analyzed. results show that when the edge rolling reduction is increased from 0 mm to 2 mm, the compressive stress in plate corner clearly increases in edge roiling process, and the zone of tensile stress during whole rolling reduction; when the edge rolling reduction increases was from 2 mm to 5 mm, the compressive stress in the plate corner seldom changes, and the compressive stress decreases after the horizontal rolling.