同种骨髓移植后的粒系前体细胞群

来源 :国外医学(内科学分册) | 被引量 : 0次 | 上传用户:pandanemo
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
用多元回归分析73例骨髓移植的重型再生障碍性贫血(SAA)患者,显示移植排斥与植入的骨髓细胞量少于3×10~8个有核细胞/kg 有明显关系。但测定骨髓有核细胞仅能粗略估计输入干细胞的数量,本文测定粒系集落形成细胞(CFU-c),试图探索输入的CFU-c 量与移植成败的关系。病人和方法 10例均符合 SAA 标准,其中原发性7例,肝炎后1例,2例属骨髓再生障碍期的阵发性睡眠性血红蛋白尿。均以环磷酰胺(60mg/kg 5和4天)和800rad(1天)全身照射作移植前准备.采用1970年 Pike 和 Robinson 的方法测定 CFU-c。供者骨髓 CFU-c 从输入的骨髓中取样测定。培养(?)天.结果所有患者在9~14天骨髓重建,无1例移植排斥。平均15天(11~18天)可见到中性粒细胞在血中重现,22天(14~30天)达1×10~9/L,为供者平均献出其骨髓有核细胞总数的2.4±0.4%或 CFU-c总数的1.50±0.2%。移植前受者 CFU-c 极低,移植时接受3.5±0.4×10~8个有核细胞/kg 或1.19±0.32×10~5CFU-c/kg。移植后第10天骨髓 CFU-c 变 Multiple regression analysis of 73 patients with severe aplastic anemia (SAA) who underwent bone marrow transplantation showed a significant relationship between graft rejection and the number of implanted bone marrow cells less than 3 × 10 ~ 8 nucleated cells / kg. However, the measurement of bone marrow nucleated cells can only roughly estimate the number of input stem cells. In this paper, we measured the number of CFU-c in CFU-c and explored the relationship between the amount of CFU-c and the success of transplantation. The patients and methods all met SAA criteria in 10 cases, including 7 cases of primary, 1 case of hepatitis and 2 cases of paroxysmal nocturnal hemoglobinuria with bone marrow aplastic. Pretreatment preparation was performed with cyclophosphamide (60 mg / kg at 5 and 4 days) and 800 rad (1 day) whole body irradiation. CFU-c was determined using the method of Pike and Robinson in 1970. Donor bone marrow CFU-c was sampled from the input bone marrow. (?) Days.Results All patients had bone marrow reconstructions at 9 to 14 days, and none of them had transplant rejection. On the average of 15 days (11-18 days), neutrophils could be seen in the blood, and reached the level of 1 × 10 ~ 9 / L in 22 days (14-30 days), giving the average number of bone marrow nucleated cells Of 2.4 ± 0.4% or 1.50 ± 0.2% of the total CFU-c. Before transplantation, CFU-c was extremely low and received 3.5 ± 0.4 × 10 ~ 8 nucleated cells / kg or 1.19 ± 0.32 × 10 ~ 5CFU-c / kg. Bone marrow CFU-c changes on the 10th day after transplantation
其他文献
2001年7月19日晚20时30分左右,我刚从亲戚家出来.当时天已经黑了,在我走到东山(矿区)时,一抬头,看见天上有亮光在晃动.开始我认为是小孩用手电筒向天上照着玩,划着圈子;但又
目的:观察应用Q开关755nm激光治疗雀斑及雀斑样痣的疗效.方法:采用Q开关755nm激光,能量密度为5~10J/cm2;频率5~10Hz;2~3mm光斑直径;Q开关532nm,能量密度2~4J/cm2;频率5~10Hz, 2~3mm
目的:观察CO_2激光与Ho:YAG激光联合应用治疗头面部角化棘皮瘤的疗效。方法:对2001年1月~2007年12月收治的7例头面部角化棘皮瘤患者采用CO_2激光和Ho:YAG激光联合治疗,观察其
请下载后查看,本文暂不支持在线获取查看简介。 Please download to view, this article does not support online access to view profile.
期刊
对激光熔覆修复表面带铬层的TC2钛合金构件进行了研究。结果表明,熔覆修复层的显微组织从界面往上依次由平面晶、细晶层和中部细小的树枝晶构成,主要元素Ni和Cr在截面内均匀
某隧道隧址区工程地质环境复杂、 地应力量值较高,面临高地应力灾害问题等潜在灾害.因此,对其开展初始地应力场与岩爆发育分析有重要意义,也为以后遇到此类工程问题提供一个
对ZL114A铝合金进行了YAG激光填丝焊接实验,研究了激光焊接工艺参数与焊缝成形质量的关系,并利用光学显微镜、扫描电镜(SEM)、能谱(EDS)等实验方法分析了ZL114A激光填丝焊接
为了获得平整的熔覆层表面质量,采用正交试验方法对316L不锈钢激光熔覆工艺参数对熔覆层截面表面平整度的影响进行了实验研究,并获得了优化的工艺参数。研究结果表明:扫描速度及
期刊
为了研究工艺参数对45~#钢表面WC-Co熔覆层组织及性能的影响,采用5kWCO_2激光器在45~#钢表面激光熔覆WC-Co涂层。利用SEM观察、显微硬度测试手段,研究了激光功率、扫描速度对