论文部分内容阅读
图內上图所示的弧形連鑄装置,高度此一般弧形連鑄装置降低了,而且大大减少了制造費用。其結晶器設在通过結晶器曲率中心的水平面的下側。通过曲率中心和結晶器內弯曲壁上緣的平面和通过曲率中心的水平面构成的夹角α在20°～80°之間。如果α角大于80°,則会象水平連鑄装置一样产生操作上的困难;如果α角减小到20°以下,则其高度不会比一般弧形連鑄装
The figure shows the arc continuous casting device, the height of the arc continuous casting device is reduced, and greatly reduce manufacturing costs. The mold is provided on the lower side of the horizontal plane passing through the center of curvature of the mold. The angle α formed by the center of curvature and the plane of the upper edge of the curved wall in the mold and the horizontal plane passing through the center of the curvature is between 20 ° and 80 °. If the angle α is greater than 80 °, there will be operational difficulties as horizontal continuous casting; if the angle α is reduced below 20 °,