橡皮树春季出室后,一般要对母株整形修剪。剪下的枝条经秋冬两季的生长都很充实,扦插易成活,可繁殖大量新株。将剪下的枝条每3节截为一段,上口平剪,下口斜剪,用利刀修平剪口。立即用草木灰吸干伤口。顶芽部位的插穗可去掉下部叶片,只保留顶芽和最上部一片叶,扦插于素沙中。其余的枝段保留最上部一枚叶片,下部叶片带腋芽和少许木质部用利刀剜下。方法为:于芽下约0.5厘米处横切一刀达木质部,于芽上0.5厘米向下斜切,两刀相交即可。伤口用草木灰封住。也可每叶一段断开,下剪口位于节下(叶柄基部)1厘米左右。为减少叶面蒸发.可将叶片卷成筒并用绳捆住。将处理好的插穗插于素沙土中。用细杆通过叶筒立杆扶持,以防倒伏。带长枝的人土3～5厘米,一叶一段或仅带腋芽的,腋芽与沙面齐平即 After the spring out of the rubber tree, the general shape of the parent plant pruning. Cut branches after the growth of autumn and winter are very substantial, cuttings survive, can reproduce a large number of new strains. The cut branches cut into sections for every 3 sections, the upper mouth flat cut, the next cut oblique cut, trim with a sharp knife cut mouth. Immediately dry the wound with grass ash. Cuttings at the top of the bud can be removed from the lower leaves, leaving only the top bud and the uppermost leaf, cuttings in the sands. The remaining branches retain the uppermost leaf, the lower leaves with axillary buds and a few xylem cut with a knife. Method: about 0.5 cm under the bud at the crosscut knife up to the xylem, 0.5 cm in the bud downward chamfer, the intersection of two knives can be. The wounds were sealed with grass ash. Can also be a section of each leaf, the next notch is located under the section (petioles base) about 1 cm. To reduce leaf evaporation, leaves can be rolled into tubes and tied with string. Will handle the cut inserted in the sandy soil. With thin rod through the cylinder pole pole support, to prevent lodging. People with long branches of soil 3 to 5 cm, a leaf or axillary buds with only axillary buds flush with the sand that is