一、离心机的整机轴线与每滚轮组径向水平中分线的垂直度(见图1) 图1 离心机平面图 1——整机(主)轴线;2——整机(副)轴线;3——单组滚轮轴战;4——滚轮组径向水平中分线在许多生产环形电杆的厂家,离心机串模的现象相当普遍,只是程度不同而已。串模常常造成杆模跑轮轮缘磨损失效,甚至因磨损阻力过大,导致敞车的后果。 First, the vertical axis of the centrifuge axis and the radial line of each roller group (see Figure 1) Figure 1 centrifuge plane 1 - the whole (main) axis; 2 - the entire (sub) axis ; 3 - single set of roller axis warfare; 4 - roller group radial horizontal split line In many manufacturers producing circular pole, the phenomenon of centrifuge serial mode is quite common, but the degree is different. Series molding often results in failure of the wear of the rim of the caster wheel, even if the wear resistance is too large, resulting in the consequences of the open car.