【摘 要】
：
The effects of rare earth element cerium on composition and electrochemical characteristics of electroless Co-Ni-B alloy were studied in this paper. The alloy c
【机 构】
：
College of Material Science and Engineering
论文部分内容阅读
The effects of rare earth element cerium on composition and electrochemical characteristics of electroless Co-Ni-B alloy were studied in this paper. The alloy component was analyzed using Inductively Coupled Plasma (ICP). The plating rate is was determined by electronic balance. The cathode polarization curves and cyclic voltammogram during the electroless deposition were tested by LK998Ⅱmodel electrochemical analytical system. The results show that rare earth element Ce can co-deposit with cobalt-based alloy, and with mass increase of Ce added in aqueous solution, the contents of Co, Ni, Ce in alloy increase and the content of B decreases. Ce can increase deposition rate of alloy in some range. The rare earth makes deposition potential move to positive direction and makes polarizability decrease.
其他文献
The microstructures of the AZ91D die-cast magnesium alloy were investigated by scanning electron microscopy (SEM), X-ray diffractometry (XRD) and energy dispers
Based on the heat transfer theory and liquid solidification theory, the heat transfer during the rapid solidification process of amorphous ribbons prepared by m
The vesicant problem during the process of preparing closed-cell aluminum foam by molten body transitional foaming process was discussed and the effect of granu
A stable δ- and β-bismuth trioxide was prepared at room temperature by vacuum vapor-phase oxidation. The average crystal size of products was 14.6 nm (by XRD)
SiCp/Gr/2024Al metal matrix composites were processed by squeeze casting technology. The microstructure of composites was observed by SEM and TEM, and the effec
This research indicates that the gradient of internal relative humidity (IRH) decreases rapidly within 7-day curing age in HPC.The amount of water imported by p
Twin-roll thin strip casting process combines casting and hot rolling into a single process,in which thermal stress and thermal mechanical stress were involved.
Comparing with that of low-calcium fly ash (LF) or fly dreg (FD), chemical content of high-calcium fly ash (HF) waves more much. Coarse grain, which existing in
Bulk Sm2Fe17Nx sintering magnet was fabricated by spark plasma sintering(SPS) technique. The effects of sintering pressure and sintering temperature on the magn
The rare earths of ytterbium, lanthanum, praseodymium, neodymium and their binary mixtures were respectively added into the traditional electroless plating solu