论文部分内容阅读
我院与衡阳市机械设备厂合作研制了输液瓶自控冲水器,经两年多制剂生产实际应用。效果满意,现简介如下:一、结构与装置(参看附图)说明:蒸馏水贮水桶与输液瓶自控冲水器高度差≥5米,进水口径φ6毫米,出水口径φ2.5毫米。喷柱高度≥1米。本器系全优质不锈钢制成。采用高位静压装置,将蒸馏水贮水桶(器)置于5米左右高度利用落差压工作,本器置工作台上,接通注射用水,水压一般在0.3～1kg/cm~2即可,当输液瓶倒置于瓶架上,即将活塞压下,注射用水由喷嘴喷出,直至瓶底,活塞是利用水压浮动封闭的,瓶子拿出时,活塞自动顶起喷口闭塞,喷水停止.因喷嘴伸入瓶口内,瓶口不与任何物体接触,冲洗过程中,水流
Our hospital and Hengyang City Machinery Factory cooperation in the development of infusion bottle controlled flusher, after more than two years of practical application of preparation production. Results are satisfactory, the introduction is as follows: First, the structure and device (see attached map) Description: Distilled water storage bucket and infusion bottle height difference between controlled flusher ≥ 5 meters, inlet diameter φ6 mm, outlet diameter φ2.5 mm. Spout height ≥1 m. This device is made of high quality stainless steel. The use of high static pressure device, the distilled water bucket (device) placed about 5 meters height using the drop pressure work, the device home table, connected to the injection of water, the water pressure is generally 0.3 ~ 1kg / cm ~ 2, When the infusion bottle is placed on the bottle rack, the piston is about to be pressed down. The injection water is sprayed from the spray nozzle until the bottom of the bottle. The plunger is closed by water pressure. When the bottle is taken out, the plunger automatically lifts the nozzle and stops. Due to the nozzle into the bottle, the bottle does not contact with any object, flushing process, water flow