论文部分内容阅读
随着产品的引进开发,从国外引进了不少模具;我厂自1982年以来先后从日本几家公司引进了180套冷冲模具。这些引入的模具,或由于国内的设备不能完全满足其精度要求,或由于缺乏严格的管理,或由于操作者的素质较差等原因,导致了引进的模具损坏严重。有的模具只使用了几万次就已损坏,严重影响生产的正常进行。若重新从国外引进,一是时间紧迫,二是外汇耗费甚大;欲自己制造,则往往还难以达到原设计的精度
With the introduction of product development, introduced a lot of mold from abroad; I plant since 1982, several Japanese companies have introduced 180 sets of Die. These imported molds, or due to the domestic equipment can not fully meet their accuracy requirements, or due to lack of strict management, or because of the poor quality of the operator and other reasons, resulting in serious damage to the introduction of the mold. Some molds used only tens of thousands of times have been damaged, seriously affecting the normal production. If re-introduced from abroad, first, time is tight, and second, foreign exchange is very expensive; to make their own, it is often difficult to achieve the original design accuracy