圆锥型模板是木模板中较为复杂的活,目前一般有二种做法:1.以尺_水为半径制做木带,并把木带按圆锥的坡度锯出斜度,然后和模板相钉,如图1所示。这种方法尺寸准确,但木带与模板不垂直相钉,不利于模板的受力、制做与安装。2.以尺_水为半径制做木带,和模板垂直相钉,如图2所示。这种方法 The conical template is a relatively complex activity in the wood formwork. At present, there are generally two approaches: 1. Make a wood band with a ruler_water radius, and saw the slope of the tape along the slope of the cone, and then nail it to the template. ,As shown in Figure 1. This method is accurate in size, but the wood strip and the template are not perpendicular to each other, which is not conducive to the force, system and installation of the template. 2. Take the ruler_water as the radius to make the wood tape, and the template is nailed perpendicularly, as shown in Figure 2. This method